[. . . ] BostonAcoustics
CRB Mounting Bracket
INST ALLA TION INSTRUCTIONS
Note: This mounting bracket is designed for use with the Boston Acoustics CR6 and CR7 loudspeaker systems. [. . . ] Alternatively, you may wish to obtain wood screws for wood or wall studs, molly bolts or screw anchors for drywall or plaster, or masonry anchors for masonry.
INSTALLATION
· Determine the mounting orientation.
Horizontally, with adjustable tilt downward
Vertically, with adjustable pivot side-to-side
· Identify the appropriate holes on the back of the speaker for the BRACKET:
Boston
For horizontal mounting, use these holes
Boston
Boston
Boston
For vertical mounting, use these holes
· Install the speaker RETAINER WASHERS: Install two of the #10 x 3/4" SELF-THREADING SCREWS and matching RETAINER WASHERS into the pair of holes you identified above. CAUTION: USE ONLY THE CORRECT #10 SCREWS SUPPLIED.
· Drill the wall holes:
Horizontal mounting arrows pointing up
Vertical mounting, left speaker arrows pointing left
Vertical mounting, right speaker arrows pointing right
Holding the BASEPLATE in position as a template, mark the centers of the two elongated mounting holes with a pencil. Drill 5/8" (15mm) holes in the wall for the supplied toggle bolts.
Fit a SQUARE NUT into the square well on the back of the BASEPLATE. (Use a finger to hold the SQUARE NUT in position until the baseplate is on the wall. )
· Fit the MOUNTING SCREWS onto the BASEPLATE: Loosely assemble two long machine screws and two toggle bolts through the elongated mounting holes in either end of the baseplate.
· Mount the BASEPLATE on the wall: Orient the BASEPLATE over the holes you drilled. Tighten MOUNTING SCREWS firmly, making sure TOGGLE BOLTS are properly seated.
· Fit BRACKET onto BASEPLATE: Position BRACKET on baseplate so that BRACKET's plain end (without the flange and T-slots) is toward the direction of arrows on BASEPLATE. Assemble CLAMP over BRACKET so that ribbed (open) side of CLAMP faces up, away from the BRACKET as shown. [. . . ] Wiggle speaker slightly to make sure both of the pins on the speaker are fully engaged into the bottom of the T-slots.
BostonAcoustics
300 Jubilee Drive Peabody, MA 01960 508-538-5000
Boston and Boston Acoustics are registered trademarks of Boston Acoustics, Inc. [. . . ]